Enter Manually (1) Click on Change button (2) Enter location info, i.e., latitude and longitude number (GPS coordinates). Set Location and Atmospheric Parameters If the observation site is near equators (lower latitude), or is at high elevation (3000 meter or higher above sea level), please enter the barometric pressure and temperature as precise as possible. However, we recommend to take the dark frame when performing polar align since the temperature difference could have large impact on the alignment. You may check Auto-Load Last Dark Frame box to load the dark frame automatically. Follow the instruction on the screen to complete the process. Click on Settings to bring up Settings window.
This will mark the bad pixels of the camera, if there is any, and camera dark current under different ambient temperature.
Take Dark Frame Take the dark frame image of the camera. Make sure to change "camera privacy" settings to allow apps to use the camera. NOTE: If the software cannot connect to the camera, please check your computer camera settings. The software will start to initialize the process if the camera is connected successfully. (2) Click on Connect button to connect the ipolar to the computer. Resize the window to fit your computer screen. Connect ipolar in Software (1) Run downloaded ipolar Software (3339_iOptron_iPolar.exe) to bring up the polar alignment main menu. Roughly point the mount to the north (or south if located in southern hemisphere). Polar Alignment Step 1: Adjust Equatorial Mount Pointing Direction Set the counterweight shaft at the lowest point.
#Auto clicker by polar 2.1 free download 64 Bit
If not, please make sure the USB cable is plugged in firmly on both ends (3) You should see ioptron ipolar under Camera in computer Device Manager (4) Goto to download ipolar software and save on your computer (5) The ipolar software needs Windows 7, 8.1, 10 or later version, 32 bit or 64 bit operation system, Framework 4.8 or later version.
#Auto clicker by polar 2.1 free download install
Connect ipolar to a PC and Download ipolar Software (1) Connect the ipolar Electronic Polar Scope (ipolar) to your computer USB port (2) The ipolar should automatically install the driver if it is the first time connecting to the computer.